Submersible Pumps 1HP to 3HP

Submersible Pumps 1HP

Submersible Pump 1HP

Submersible Pump 1.5HP

Submersible Pump 2HP

Submersible Pump 3HP

Features

Oil Filled Motor
The motor are designed for a wide voltage range of operation and are suitable for installation in areas experiencing wide voltage fluctuations.
Motors are designed using enameled copper wire instead of PVC insulated copper wire.
Due to this the design is highly efficient reducing power consumption & thereby reducing cost of operations.
The motors are filled with special food non-toxic dielectric oil, which lubricates the ball bearing and axial thrust bearings. It also offers insulation and thermal properties which increases the reliability & working life of the motor.
Outer casing of the motor is constructed completely with Stainless Steels, Which reduce corrosion and gives a good overall appearance to the motor.
The motors are compact and weigh substantially less, which facilities transportation storage & installation.
The electric cable of the motor constitutes three-wire removable cable with waterproof connector. This facilitates the changing of the cable, if required, without dismantling capacitors.
All rotating components and assemblies are dynamically balanced to ensure long bearing life and vibrations free smooth operations.
The motor are permanently split capacitor motors, which do not require the starting capacitors. Due to this cost of the control box reduce substantially, thereby reducing the cost of installations.
The pump sets are compact and slim and can be easily installed in narrow wells.

SPECIFICATIONS

Power Range	0.75kw/1.0HP (10 stage)
Version	180-240V 1Ph, 50Hz in water filled, 140-240V 1Ph, 50Hz in oil filled
Speed	2800rpm
Flow Rate	0.2-1.25 lps
Total Head Range	10-70 meters
Outlet size in inches	1" & 1"
Degree of Protection	IP 58
Direction of Rotation	CCW -1 Ph
Maximum outer diameter	76mm
Type of duty	S1 (Continuous)

Material of Construction
Motor Body	Stainless Steel
Stator	Vacuum Impregnated with class F insulations
Rotor	Aluminum pressure die cast
Winding	Enamelled copper wire with class F insulations
Bearing	Heavy duty angular contact bearing/ ball bearing
Bowl	High grade Noryal
Wear Rings	High quality abrasion resistant P.U.
Seal	Mechanical Seal
Diaphragm	Adequately sized to accommodate pressure difference of oil inside the motor and prevent loss of oil
Impeller	High quality abrasion resistant Noryal & dynamically balanced.
Shaft	Stainless Steel of adequate diameter to ensure rigidity and ground to close tolerances.
Suction Casing	Provided with perforated Stainless Steel Strainer and adequately sizes to allow the water to be sucked in with minimum friction.
Cable Sealing Arrangement	Designed so that no bore well water with sand can enter the motor.